How To Light Pilot Light On Gas Fireplace Insert. Press and hold down the gas control knob, then press the igniter button multiple times, as needed, until the pilot flame ignites. Often, this will involve manually depressing the pilot valve and using an electric ignitor or match to light the pilot.
You can adjust the flame height by turning the gas key. If the log set has a switch on it, place it in the off position. If the pilot does not light, wait 5 minutes and try again.
Depending On How Long It’s Been Since The Gas Fireplace Was Last Used, Ignition May Take Multiple Attempts.
If yours appears to be the mirror image of picture #4, then the word “pilot” will be in the 12 o’clock position to light the pilot, and “on” will be set to the 12 o’clock position to turn on your main burner. Keep a close eye on your pilot light once you have restored the flame. Turn the safety control valve knob to the pilot position.
It Should Be Labeled With The Words On, Off, And Pilot. Turn It Past The First Two Settings To The One Labeled Pilot.
After the pilot lights, keep the pilot button held down about 15 to 30 seconds to warm up the thermocouple and ensure that the flame stays lit. Once you insert the key, do not turn it until after preparing your lighter, otherwise you may release a dangerous amount of gas into the room. Next, light your lighter and put its flame near the pilot light inside the fireplace or furnace, or press the clicker button to make sure that it is sparking (this may be hard to see in some fireplaces).now press the knob, or a button near the knob, to get gas flowing to the pilot light.often, this will involve manually depressing the pilot valve and using an electric ignitor or.
Depending On How Long It’s Been Since The Gas Fireplace Was Last Used, Ignition May Take Several Attempts Before Igniting.
Once the pilot lights, keep holding down the gas control knob for 20 to 30 seconds to allow time for heating up the thermocouple (a safety device), then release the knob so it pops back up. Once you have given any excess gas a chance to dissipate, follow the instructions in your system’s manual to relight the pilot. Reset the knob to the pilot position:
If The Pilot Does Not Light, Wait 5 Minutes And Try Again.
Press down on the knob that controls your propane fireplace. After the pilot lights, keep the pilot button held down for about 15 to 30 seconds to warm up the thermocouple and ensure that the flame stays lit. Because these systems do not rely on external electricity, they work seamlessly even if the power goes out for an extended period of time.
Light A Match Or Butane Candle Lighter And Hold It Near The Burner In The Fireplace.
Newer generations of gas fireplaces and appliances use an electronic ignition system. Ignite the pilot light : To ignite your device's pilot light, you'll need to insert a fireplace key into the gas valve knob located to the left or right of the fireplace.
